Casio KL-100 User Manual

E-21
Message
ERR!
* This message
appears on the
screen for about
one second.
FUL!
* This message
appears on the
screen for about
one second.
BATT
ERR!
Possible Causes
• Attempt to input two B
marks within the same
text.
• Attempt to input B mark
while 6mm is specified as
the tape width.
• Label text containing a
B mark was input and
then tape width specifica-
tion was changed to
6mm. (ERR! message
appears when you try to
perform a print operation.)
• Text that is longer than
5.5cm when stamp
printing is selected.
• Attempt to print a stamp
or frame while 6mm is
specified for the tape
width.
• Both text memory areas
(AREA 1 and AREA 2)
already contain text.
• Battery power is too low.
• Memory data has become
corrupted for some
reason.
Action
• Use only one B mark.
Only two lines of text can
be input, so text can
contain only one B
mark.
• Do not use B marks.
6mm tape can have only
one line of text, so text
cannot contain any B
marks.
• Delete the B mark to
print on 6mm tape or
switch back to a wider
tape.
• Shorten the text to be
printed and try again.
• Change the tape width
setting to OFF and try
printing the stamp again.
• Delete text from one of
the text memory areas
and then store the new
text.
• Replace batteries.
• Initialize the Label
Printer.
Error Messages Alpha Characters
Symbols

Casio KL-100 Specifications

General

Brand	Casio
Model	KL-100
Category	Label Maker
Language	English