EN-56
Recording and Playback
Perform the steps below to record your keyboard play
to Digital Piano Memory.
1.
Configure the tone, rhythm, and other
settings you want to use.
• The settings you configure here will be included as
part of the recorded MIDI data.
• For details about what is included in the recorded
MIDI data, see “System Track” (page EN-57).
2.
On the MENU screen, touch “MIDI
RECORDER”.
3.
Touch “0”.
This turns on the recorder and enters record mode.
• Each touch of “0” cycles through modes as shown
below.
Playback mode
Recording mode
4.
Touch “New Data”.
This enables recording of new data to the system track.
5.
Play something on the keyboard.
Recording starts as soon as you play something.
• You can also start recording by touching “X”.
• You also can configure the piano so Auto
Accompaniment is included in the recorded data.
• The 4 MIDI a button is lit while recording is in
progress.
6.
After you finish recording, touch “Y”.
This causes the 3 REC MODE button and 4 MIDI
a button lamps to become unlit, and enters the
playback mode.
• You can also enter the recording mode by pressing
the 3 REC MODE button and then touching
“MIDI RECORDER”. This method can be used to
enter the recording mode only for making a new
recording.
• Recording memory capacity is approximately 50,000
notes per song. When remaining capacity is 100 or
fewer notes, the 4 MIDI a button lamp will
flash at high speed. Recording will stop
automatically when the allowable limit is reached.
• The Digital Piano has memory for 100 songs.
• If power to the Digital Piano is cut off while recording
is in progress, everything you recorded up to that
point will be lost. Take care so power is not turned
off accidentally during recording operations.
Recording to Digital Piano
Memory (MIDI Recorder)
Unlit
Lit Flashing
Unlit: Playback mode
PX560-ES-1A.indd 58 2015/06/18 14:53:50
To Next Page
Loading...
Need help?
General
