— 10 —
3. DISASSEMBLY
NOTE:
* Please make a back-up copy of the clients’ data before disassembling.
* When the power is turned off, the internal battery enables the hibernate function.
* There are several kinds of screws. Be sure to use the
correct type of screws when reassembling.
It is advisable to sort the screws as shown in the right
after removing them.
* When assembling/disassembling the Stand, be careful not to get the fingers caught.
* Use caution when handling the LCD unit and the inverter for the backlight as there is the risk of
high-voltage electrical shock.
* Internal battery:
• Do not disassemble or short-circuit the battery.
• Do not place the battery near a heat source or expose it to direct flame or heat.
• Place the battery with its (+) and (-) terminals in the correct orientation.
• Do not recharge the battery. (Primary battery)
* When assembling, be sure that it is free of dust and other foreign matters.
Pay special attention when replacing the touch panel and LCD
* Do not tangle the cables in principle.
To Next Page
Loading...
Need help?
General
