OTHER SETTINGS
134
Using the Alarm
You can configure up to three alarms that cause the
camera to beep and display a specified image at the time
you specify.
• You can configure up to three alarms, named “Alarm 1”,
“Alarm 2”, and “Alarm 3”.
To set an alarm
1.
In the PLAY mode, press [MENU].
2.
Select the “PLAY” tab, select “Alarm”, and
then press [].
3.
Use [] and [] to select the alarm (1, 2, or 3)
whose setting you want to configure, and
then press [].
4.
Use [] and [] to select the setting you want
to change, and then use [] and [] to
change the selected setting.
• You can set an alarm time and configure the alarm to
sound only once (Once) or at the same time
everyday (Daily). You can also turn the alarm on or
off.
5.
Press [DISP].
• You could press [SET] in place of [DISP] if you want
to configure the alarm without an image.
6.
Use [] and [] to select the scene you want
to appear at the alarm time, and then press
[SET].
7.
After all the settings are the way you want,
press [SET].
To Next Page
Loading...
Need help?
General
