– 19 –
SE-S400/SE-S800/PCR-T500/PCR-T520/SE-C450
SE-S3000/SE-S900/PCR-T2300/PCR-T2400/SE-C3500
5. DIAGNOSTIC PROGRAM
5-1. Launching The Diagnostic Program
(1) Set the paper.
(2) Perform initialization.
Plug the power cord to a power outlet with the Mode Switch OFF.
While pressing the keys below, turn the Mode Switch to [PGM].
One-printer model [FEED]
Two-printer model [JOURNAL FEED]
Initialization is complete when "INIT" appears on the Main Display.
INIT
0000000000
(3) Press
99990000s
.
(4) The diagnostic program starts and the version information of the diagnostic program is
automatically printed.
NOTE: Once the program starts, the status is displayed.
Boot Ver : xxxx xxxxxx
Apli Ver : xxxx xxxxxx
← Version
← Diag Version
5-2. Exiting the Diagnostic Program
(1) Turn the Mode Switch to [OFF].
(2) Perform initialization.
(3) Unplug the Power cord.
To Next Page
Loading...
Need help?
General
