Selecting and Playing a Tone
E-19
1.
Press the L-9 (METRONOME) button.
• This will start the metronome.
• The display will show the tempo along with a count of
the measures and beats since you started the
metronome.
2.
Press the L-9 (METRONOME) button again to
stop the metronome.
1.
Hold down the L-9 (BEAT) button until the
metronome beat screen shown below appears
on the display.
2.
Use the dial or R-14 (–, +) buttons to select a
beat setting.
• You can select 0, or a value within the range of 2 to 6.
Specifying 0 for this setting will cause each beat to be
indicated by the same sound (no chime at the
beginning of each measure).
3.
Press the L-9 (BEAT) or R-15 (EXIT) button.
• This exits the metronome beat screen.
There are two different methods you can use to change the
tempo setting: using the TEMPO buttons or tapping a beat
with a button.
■ To change the tempo using the TEMPO buttons
1.
Press the L-10 (TEMPO w) (slower) or L-11
(TEMPO q) (faster) button.
• This displays the tempo screen shown below.
• If you do not perform any operation for a few seconds,
the display will return to previous screen automatically.
2.
Use the L-10 (TEMPO w) and L-11 (TEMPO q)
buttons to change the tempo (beats per
minute).
• Holding down either button will scroll the setting values
at high speed.
• You can specify a tempo value in the range of 30 to
255.
3.
Press the R-15 (EXIT) button.
• This exits the tempo screen.
Using the Metronome
To change the beats per measure
Tempo
Measure
Beat
To change the tempo setting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
