40
Projector operations are performed using the remote controller that comes with it. Point the remote
controller signal emitter at one of the signal receivers on the projector as you perform remote
controller key operations. The maximum range of the remote controller signal is approximately
5 meters (16.4 feet) (between signal emitter and receiver).
Important!
To avoid running down the batteries, store the remote control unit so its keys are not pressed
inadvertently.
Specifications are subject to change without notice.
Remote Controller
Remote control signal emitter
Turns power on or off.
Press to exit the currently displayed menu or to cancel an
operation.
Keys used when configuring the remote ID setting (page 56)
and when performing countdown timer operations (page 56).
Use the cursor keys ([][][][]) to move between menu
items, and to change setting values. Press the [ENTER] key to
select a menu item or to execute a function.
Press each of these keys to execute their functions. For
information about the function of each key, see “Operating the
Projector” (page 41).
To Next Page
Loading...
Need help?
General
