47
Auto Projection Off automatically turns off the projection light approximately 10 seconds*
1
after the
input signal from an input source is lost during projection. The light will turn back on if the input signal
from the original input source is restored within 20 minutes*
2
after the light is turned off.
Auto Projection Off Operation Example
The example below shows an image of how Auto Projection Off works when multiple users alternately
connect to the projector.
Though the above example shows a cable connection, the same also applies to wireless LAN
connection.
Using Auto Projection Off
*1 A message first appears about five seconds after the input signal is lost, and then the light is turned
off five seconds after that.
*2 The projector automatically turns off if the input source is not restored within 20 minutes.
Cable unplugged.
Cable plugged in.
User 1
User 2
POWER/STANDBY
flashes green.
Light turns off after about 10 seconds.
POWER/STANDBY
lights green.
Projection resumes automatically.
To Next Page
Loading...
Need help?
General
