Casio XJ-UT Series User Manual

21
Getting Ready
As you unpack the projector, check to make sure that all of the items listed below are present.
 Projector
 Wireless remote controller YT-161
 Test Batteries (AAA-size × 2)
 AC Power Cord
 Cable cover (XJ-UT Series only)
 Wireless adapter YW-41 (XJ-UT312WN only)
 “Where to find the User’s Guide” sheet
 Warranty
This section explains the operational flow up to the point that projection is started.
1. Load the test batteries that come with the projector into the remote controller.
 Use only alkaline batteries to power the remote controller.
 Orient batteries as shown by the polarity figures ( ) inside the battery compartment.
2. Place the projector onto a table, desk, or stand that is level and firm, making
sure that you allow enough room around it.
 “Safety Precautions” (page 7), “Operating Precautions” (page 13)
 “Placing the Projector on a Desk or on the Floor” (page 28), “Setup Precautions” (page 30)
You will need to purchase special hardware to mount this projector on a wall. For details, contact
the retailer where you purchased the projector.
3. Adjust the vertical angle of the projector.
 “Adjusting the Vertical Angle of the Projector” (page 28)
4. Use the supplied power cord to plug the projector into a power outlet.
5. Connect the projector to an image output device and/or audio output device, and
then turn on each device.
 “Connecting with Another Device” (page 31)
6. Press the [P] key to turn on the projector.
 The first time you turn on the projector, a “Language” window will appear in the center of the
projection screen. Select the language you want.
Unpacking
Operation Flow to Projection

Casio XJ-UT Series Specifications

General

Brand	Casio
Model	XJ-UT Series
Category	Projector
Language	English