Casio XJ-V10X User Manual

8
 Mercury-free Hybrid Light Source
A CASIO-original laser and LED hybrid light source enables high luminance, low power
consumption, and low running cost. This projector does not use a mercury lamp, making it
environmentally friendly.
 No-wait Projection
A CASIO hybrid light source reaches maximum brightness immediately after power is turned on,
compared with a wait of approximately one minute normally required with a mercury lamp. The light
source will even reach maximum brightness immediately if you turn it back on right after you turn it
off. A mercury lamp requires a longer wait in this case to cool down.
 Quick and simple light adjustment (Instant Light Control)
A simple key operation instantly adjusts light output to one of seven levels.
 Auto light adjustment using a light sensor (Intelligent Light Control)
The projector senses surrounding light levels and adjusts light output automatically as required for
efficient low-power operation. (Requires “Light Sensor” setting to be set to “On”.)
 Support for five input sources
Analog RGB, component video (Y·Cb·Cr, Y·Pb·Pr), HDMI, composite video, and S-video input
sources are supported. Two HDMI inputs are provided.
 Vertical Keystone Correction
Manual adjustment to correct for vertical keystoning (distortion of the projected image shape
caused when projecting from below or above the projection surface) and return the projected image
to a rectangular shape.
 Power supply to external equipment
A 5V DC terminal enables power supply to external equipment.
 Temporary blanking of projection without cutting power
Turning off projector power also cuts power being supplied to external equipment. To prevent this,
a [BLANK] key lets you temporarily stop projection without interrupting the power supply.
 16W built-in speaker
Audio from the input source can be output from the projector’s built-in speaker.
 Ceiling Mounted and Rear Projection Support
The projector can be configured to project an image of normal orientation even when installed
upside down (for ceiling projection) or when projecting from behind the screen.
 Direct Power On
The projector can be configured to turn on automatically and start projecting as soon as it is
plugged into a power outlet.
 Firmware update and user logo image data transfer
Firmware (software in the projector flash ROM) updates and user logo images can be transferred to
the projector from a computer as required.
XJ-F10X/XJ-F100W

Casio XJ-V10X Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	1.95 - 2.87 m
Projection technology	DLP
Contrast ratio (typical)	20000:1
Screen size compatibility	30 - 300 \
Projection distance (tele)	3.33 - 4.85 m
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	+ 30/ ± 30 °
Focus	Manual
Offset	50 %
Digital zoom	2 x
Optical zoom	1.5 x
Zoom capability	Yes
Focal length range	2.31 - 2.73 mm
DVI port	No
Audio (L/R) in	0
Serial interface type	RS-232C
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Maximum digital resolution	1920 x 1080 pixels
Operating temperature (T-T)	5 - 35 °C
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	White
Power source	-
Power consumption (standby)	180 W
Service life of light source	10000 h
Service life of light source (economic mode)	6000 h
Analog signal format system	NTSC, PAL, PAL 60, PAL M, PAL N, SECAM

Weight and Dimensions

Width	299 mm
Height	97 mm
Weight	3500 g