Sounding Arpeggios Automatically
E-44
Use the procedure below to clear preset step data or step
data that was edited using Step Edit (page E-42) and create
new step data from scratch.
• Note that variation type data cannot be cleared.
1.
Hold down
bn
ARPEGGIO until the type
selection screen shown below appears on the
display.
2.
From among the preset or user arpeggio types
select the arpeggio type you want to clear.
• The procedure for selecting an arpeggio type is the
same as that for selecting a tone (page E-19).
3.
Press
7
EDIT.
4.
Use the
br
up (q) and down (w) buttons to
move the item selection cursor (0) to “Clear
Step”, and then press
br
ENTER.
5.
Press
br
ENTER again.
This should cause “Clear?” to appear on the display.
6.
Press
br
YES.
The message “Complete!” will appear on the display when
the data is cleared.
Clearing Arpeggio Data
To Next Page
Loading...
Need help?
General
