19
A larger cable may not fit the terminal connections.
• The marking of the current rating of the fuse or circuit breaker
protecting this appliance should be marked on the socket outlet.
• Assembly and electrical connection should be carried out by
specialised personnel.
• When installing this product we recommend you seek the help of
another individual.
Fitting the Hob
Unpacking the hob:
Take care not to lose or mishandle any parts.
Fitting position of the hob:
This appliance must be installed a minimum of 50mm from any back
wall and a minimum of 180mm away from any adjacent vertical surfaces,
e.g. a tall cupboard end panel. This may be reduced to 100mm if the
adjacent surface is resistant to fire (tiles or steel, for example). These
dimensions are shown in Fig. 7.
If fitting a cooker hood above the hob:
If a cooker hood is to be installed above the hob, the height of the hood
above the hob must be at least 600mm (650mm is recommended) (Fig.
8). If the instructions supplied with the hood dictate that the hood must
be installed at a height greater than 600mm, then that height is the
minimum required.
To Next Page
Loading...
Need help?
General
