Instruction Manual | 5
First use of the oven
In order to remove oil residues accumulated during the manufacturing
process and dust accumulated during storage and transport, we recommend
a preliminary cleaning before first use.
Preliminary heating
1. Remove any packaging elements from the oven cavity
2. Turn on ventilation or the extractor fan in the room or open a window
3. Set the oven to 250°C using the rapid preheating function
4. Allow to heat for approximately 30 minutes
5. Turn the oven o and allow to cool
6. To clean the oven,
use a damp cloth with warm water and a small amount
of washing up liquid
7. Dry with a clean cloth
A slightly unpleasant smell may be emitted during this process due to the
vaporising of oil residue used to protect the oven during storage.
Important! The time “0.00” will start flashing in the display upon
connection to the power supply.
The programmer should be set with the current time. (See Electronic
programmer ). If the current time is not set,
operation of the
oven is not possible.
The electronic programmer is equipped with touch sensors which are
switched on by touching or pressing the sensor surface for at least one
second.
Each sensor reaction is confirmed by a beep.
Keep the sensor surface clean at all times.
To Next Page
Loading...
Need help?
General
