11
programme is shown on the display.
• Then close the door. The dishwasher will begin the new
programme from the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel the programme once it has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold in the Programme Selection button for three
seconds until the end of programme indicator flashes and a “1”
shows on the display.
• Then close the door. The dishwasher will run a drain cycle which
will take approximately 30 seconds. Once this is complete, the
dishwasher will beep five times and the end of programme light
will switch on.
Switching the dishwasher o
• Once the dishwasher beeps five times and the end of programme
light switches on, the dishwasher can be switched o by pressing
the Power button.
• Then turn o the water tap and remove the plug from the power
socket.
Please note: The dishwasher will automatically continue on the
programme it has started if the door is opened or in the event of a
power cut and once power has been restored or the door closed.
To Next Page
Loading...
Need help?
General
