Challenger AP11LCD User Manual

AP11LCD / AP11LED Manager Guide
AP11LED/LCD-Manager- Rev 02
5
How to UNSET from Alarm and RESET the system
You can unset the system in SET and reset it after an alarm, Tamper or PA.
The system will be programmed to be reset by the user or engineer. This is dependent on System
flags set up. See Engineer mode / Setup System/ Flags 1.
e.g. Zone 3 trigger alarm
LED Remote Keypad :
· System is in Set mode.
· Enter User code/Manager code
It will stop sound in alarm and the LED keypad will
show alarm event. First event is flashing, other lit.
· Enter User code/Manager code
System returns to Day mode.
How to use Panic Alarm on keypad
Should you need to attract attention, the full alarm signal can be activated at emergency by
pressing 0 and 5 together
Press & simultaneously, the system and external sounder will sound immediately.
Note:
The engineer will need to programme this option for it to work.
0
5
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
? ? ? ?
?
?
?
?
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10

Challenger AP11LCD Specifications

General

Brand	Challenger
Model	AP11LCD
Category	Alarm system
Language	English