• Remove the protective cover from the
positive (+) battery cable, and re-
move the cable.
• Remove the battery hold down, and
remove the battery.
• Install the new battery, when install-
ing the battery, connect the positive
(+) battery cable first and then the
negative (-) battery cable.
• After the new battery is installed, the
vehicle may perform unusually while
driving. This is normal due to the en-
gine control system readapting to the
vehicle’s driving conditions.
NOTE:
Please discard the used bat-
tery for disposal to an authorized dealer
or local qualified waste disposal station.
Jump-Starting Procedures Due
to A Low Battery
WARNING!
Observe the following guidelines when
jump-starting the battery:
•
Take care to avoid the radiator cool-
ing fan whenever the hood is raised.
It can start anytime the ignition
switch is ON. Y ou can be hurt by the
fan.
(Continued)
WARNING! (Continued)
•
Do not attempt to push or tow your
vehicle to get it started. Vehicles
equipped with an automatic trans-
axle cannot be started this way. Un-
burned fuel could enter the catalytic
converter and once the engine has
started, ignite and damage the con-
verter and vehicle. If the vehicle has
a discharged battery, booster cables
may be used to obtain a start from
another vehicle. This type of start
can be dangerous if done improp-
erly, so follow this procedure care-
fully.
•
The battery used for boosting must
be 12 volts.
IN CASE OF AN EMERGENCY – 105
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
