NOTE:
The vehicle should be traveling
at a steady speed and on a level road
before pressing the ⬙SET⬙ switch.
To Deactivate
To turn the cruise control system OFF,
press the ⬙O⬙ switch or apply the ve-
hicle brake to deactivate the cruise
control. Pressing the ⬙O⬙ switch or
turning off the ignition switch erases
the set speed memory, but pressing
the brake will not erase set speed
memory.
To Vary The Set Speed
To Accelerate:
When the cruise control is ON, tapping
the ⬙+⬙ side of the ⬙RES/+⬙ switch once
will result in a 2 km/h speed increase.
If you press the ⬙+⬙ switch and hold it,
the vehicle speed will increase con-
tinually until you release it.
To Decelerate:
When the cruise control is ON, tapping
the ⬙-⬙ side of the ⬙SET/-⬙ switch once
will result in a 2 km/h speed decrease.
If you press the ⬙-⬙ switch and hold it,
the vehicle speed will decrease con-
tinually. Release the switch when the
desired speed is reached, and the
new speed will be set.
NOTE:
It is not recommended to press
and hold the ⬙+⬙ switch for an extended
time. An accident may occur.
To Accelerate for Passing
Depress the accelerator as you would
normally and accelerate to complete
the pass. When the pass is complete,
release the accelerator and allow the
vehicle to return to the prior set
speed.
To Resume Set Speed
If you deactivate the cruise control
without erasing the set speed from
memory, you can resume the set
speed by pressing the ⬙RES⬙ side of
the ⬙RES/+⬙ switch and release. Re-
sume can be used at any speed above
25 km/h.
WARNING!
Cruise control can be dangerous where
the system can’t maintain a constant
speed. Your vehicle could go too fast
for the conditions, and you could lose
control. An accident could be the re-
sult. Do not use cruise control in heavy
traffic or on roads that are winding, icy,
snow-covered, or slippery.
48 – FEATURES OF YOUR VEHICLE
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
