Don’t use any of these unless this manual says you can.
In many uses, these will damage your vehicle:
0
Alcohol
0
Laundry Soap
Bleach
Reducing Agents
Cleaning the Inside
of
Your Corvette
Use a vacuum cleaner often to get rid
of
dust and loose
dirt. Wipe vinyl or leather with a clean, damp cloth.
Your Chevrolet dealer has two GM cleaners, a
solvent-type spot lifter and a foam-type powdered
cleaner. They will clean normal spots and stains very
well.
Do
not use them on vinyl
or
leather.
Here
are
some cleaning tips:
0
Always read the instructions on the cleaner label.
Clean up stains as soon as you can
--
before they set.
Use a clean cloth or sponge, and change to a clean
area
0
Use solvent-type cleaners in a well-ventilated area
If a ring
forms
after spot cleaning, clean the entire
often. A soft brush may
be
used if stains
are
stubborn.
only. If you use them, don’t saturate the stained area.
area immediately or it will set.
Using
Foam-Type Cleaner
on
Fabric
0
0
0
0
0
0
0
0
0
0
Vacuum and brush the area to remove
any
loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the
directions on the container label.
Use suds only and apply with a clean sponge.
Don’t saturate the material.
Don’t rub it roughly.
As
soon as you’ve cleaned the section, use a sponge
to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe
off
what’s left with a slightly damp paper towel
or
cloth.
Then
dry
it immediately with a blow dryer or a heat lamp.
NOTICE:
Be careful.
A
blow dryer
or
a
heat
lamp
may
scorch
the fabric.
0
Wipe with a clean cloth.
6-56
To Next Page
Loading...
Need help?
General
