This device complies with RSS-210 of Industry Canada.
Operation is subject
to
the following two conditions:
1.
This device may not cause interference, and
2.
This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications
to
this system by other than
an authorized service facility could void authorization to
use this equipment.
At
times you may notice a decrease in range. This is
normal for any remote keyless entry system. If the
transmitter does not work or
if
you have
to
stand closer
to your vehicle for the transmitter
to
work, try this:
Check the distance. You may be
too
far from your
vehicle. You may need
to
stand closer during
rainy or snowy weather.
Check the location. Other vehicles or objects may
be blocking the signal. Take a few steps
to
the
left or right, hold the transmitter higher, and
try again.
Check to determine
if
battery replacement or
resynchronization is necessary. See “Battery
Replacement’’ and “Resynchronization” under
Remote Keyless Entry System Operation on
page
2-4.
Remote Keyless Entry System
Operation
Your vehicle may have this feature.
c
8
(Lock):
Pressing this button once will lock all of the
doors. The parking lamps will flash and the interior
lamps will turn on briefly. Press LOCK again within five
seconds and the parking lamps will flash and the
horn will chirp briefly.
If
you are still having trouble, see your dealer or a
qualified technician for service.
2-4