Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane-Change Signals. See Turn
and Lane-Change Signals on page 3-7.
• 23 Headlamp High/Low-Beam Changer.
See Headlamp High/Low-Beam Changer on
page 3-8.
• Flash-to-Pass. See Flash-to-Pass on page 3-8.
• O Exterior Lamp Control. See Headlamps
on page 3-14.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and other
drivers will not see your turn signal. If a bulb is burned
out, replace it to help avoid an accident.
If the arrows do not go on at all when you signal a turn,
check the fuse. See Fuses and Circuit Breakers on
page 5-82.
3-7
To Next Page
Loading...
Need help?
General
