9-8 Driving and Operating
To remove the air dam:
1. Remove the 2 outboard air dam
bolts.
2. With a flat‐blade tool, disengage
the snaps.
3. After the bolts are removed and
the snaps are disengaged, push
forward on the air dam until it
is free.
Notice: Operating your vehicle
for extended periods without
the front fascia lower air dam
installed can cause improper air
flow to the engine. Always be
sure to replace the front fascia
air dam when you are finished
off-road driving.
After off-roading, be sure to reinstall
the air dam:
1. Line up the snaps and push the
air dam rearward to engage the
snaps.
2. Install the 2 outboard bolts.
Loading Your Vehicle for
Off-Road Driving
{
WARNING
.
Cargo on the load floor piled
higher than the seatbacks
can be thrown forward during
a sudden stop. You or your
passengers could be injured.
Keep cargo below the top of
the seatbacks.
.
Unsecured cargo on the
load floor can be tossed
about when driving over
rough terrain. You or your
passengers can be struck by
flying objects. Secure the
cargo properly.
.
Heavy loads on the roof raise
the vehicle's center of gravity,
making it more likely to roll
over. You can be seriously or
(Continued)
WARNING (Continue d)
fatally injured if the vehicle rolls
over. Put heavy loads inside the
cargo area, not on the roof. Keep
cargo in the cargo area as far
forward and low as possible.
There are some important things to
remember about how to load your
vehicle.
.
The heaviest things should be
on the floor, forward of the rear
axle. Put heavier items as far
forward as you can.
.
Be sure the load is properly
secured, so things are not
tossed around.
You will find other important
information under Vehicle Load
Limits on page 9‑22 and Tires on
page 10‑55.
To Next Page
Loading...
Need help?
General
