Vehicle Care 10-45
3. Turn the old bulb
counterclockwise and pull the it
straight out from the socket.
4. Install a new bulb into the
socket, turn it clockwise, and
press it in until it is tight.
5. Reinstall the lens and the four
screws.
Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps
To replace one of these bulbs:
1. Open the tailgate. See Tailgate
on page 2‑10 for more
information.
2. Remove the two rear lamp
assembly screws near the
tailgate latch strikerpost and pull
rearward until disengaging the
two outer pins on the taillamp
assembly from the vehicle.
A. Stoplamp/Taillamp/Turn
Signal Lamp
B. Back-up Lamp
3. Turn the bulb socket
counterclockwise to remove it
from the taillamp assembly.
4. Pull the old bulb straight out
from the socket.
5. Press a new bulb into the socket
and turn the socket clockwise
into the taillamp assembly.
6. Reinstall the taillamp assembly.
To Next Page
Loading...
Need help?
General
