Vehicle Care 9-31
3. If replacing low/high headlamp
bulb, remove the dust cover cap
from the back of the headlamp
housing by turning the cap
counterclockwise.
4. Turn the bulb socket
counterclockwise to remove from
lamp assembly.
5. Remove the bulb from the
socket or disconnect bulb
assembly from harness
connector.
6. Install new bulb.
7. Reinstall the lamp socket to
lamp assembly turning
clockwise.
8. Replace the dust cover cap on
headlamps.
9. Reinstall the wheel well cover
access port cap and secure by
installing screw.
Fog Lamps
To replace one of these bulbs:
1. Locate the fog lamp assembly
under the front facia.
2. Disconnect the bulb socket from
the electrical connector, turn and
pull out the bulb assembly.
3. Remove the old bulb from the
bulb socket and push the new
bulb straight into the bulb socket
until it connects.
4. Push the bulb socket into the fog
lamp assembly and turn
clockwise to lock it into place.
5. Reconnect the bulb socket to the
electrical connector.
To Next Page
Loading...
Need help?
General
