Windshield
Wipers
K2244
You control the windshield wipers by turning the band with the wiper symbol
on it.
For
a single wiping cycle, turn the band to
MIST.
Hold
it there until the
wipers start, then let go. The wipers will stop after one cycle. If you want
more cycles, hold the band on
MIST
longer.
You can set the wiper speed for a long or short delay between wipes. This
can be very useful in light rain
or
snow. Turn the band to choose the delay
time. The closer to
LO,
the shorter the delay.
For steady wiping at low speed, turn the band away from you to the
LO
position. For high speed wiping, turn the band further, to
HI.
To stop the
wipers, move the band to the
off
symbol.
A
Damaged wiper blades may prevent you from seeing well enough
to
drive safely. To avoid damage, be sure to clear ice and snow from
the wiper blades before using them.
If
they’re frozen
to
the
windshield, carefully loosen
or
thaw them.
If
your blades
do
become
damaged get new blades
or
blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit breaker will stop them
until the motor cools. Clear away snow
or
ice to prevent an overload.
2-39
To Next Page
Loading...
Need help?
General
