To
put the seat back in, hold it sideways and put it into the vehicle. Turn the
seat to the forward position and set it down, with the latches at the bottom of
the seat over the hooks in the floor. Pull up on the center release handle
and let the seat drop into place. Release the handle to let the seat latch
close and make sure it locks into place. Then, move the seatback release
lever at the right rear
of
the seat toward the center
of
the vehicle and raise
the seatback.
After returning the seat back
to
the upright position, push the seatback
fonvard
to
make sure
it
is locked in place.
Then, return the outside passenger position safety belts
to
the seat frame
buckles.
A
A
safety
belt
that
is
twisted or not
properly
attached
won’t
provide
I
1
the protection needed
in
a
crash.
The
person wearing
the
belt could
be
seriously
injured. After installing
the
seat,
always
check
to
be
sure
that
the
safety
belts
are not
twisted
and
are
properly
attached.
Safety
Belts:
They’re
For
Everyone
This part
of
the manual tells you how
to
use safety belts properly. It also tells
you some things you should not
do
with safety belts.
Don’t let anyone ride where they can’t wear a safety belt properly.
If
you are in a crash and you’re not wearing a safety belt, your injuries
can be
much
worse.
You
can hit things inside the vehicle or be
.-.>
ejected from
it.
You
can be seriously injured or killed. In the same
y%
,
&:
crash, you might not be
if
you
are buckled up. Always fasten your
ik::
safety belt, and check that your passengers’ belts are fastened
properly too.
1-1
3
To Next Page
Loading...
Need help?
General
