Service
&
Appearance Care
Cleaning the Inside
of
Your
Vehjcle
Use a vacuum cleaner often to get rid of dust and loose dirt. Wipe vinyl with
a clean, damp cloth.
Your GM dealer has
two
GM cleaners-a solvent-type spot lifter and a foam-type
powdered cleaner. They will clean normal spots and stains very well.
Here are some cleaning tips:
Always read the instructions on the cleaner label.
Clean up stains as soon as you can-before they set.
Use a clean cloth
or
sponge, and change to a clean area often.
A
soft
brush may be used
if
stains are stubborn.
Use solvent-type cleaners in a well ventilated area only.
If
you use them,
don’t saturate the stained area.
If
a ring forms after spot cleaning, clean the entire area immediately
or
it
will set.
Using Foam-Type CIeaner on Fabric
Vacuum and brush the area
to
remove any loose dirt.
Always clean a whole trim panel
or
section. Mask surrounding trim along
stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the directions on the
Use suds only and apply with a clean sponge.
container label.
Don’t saturate the material.
Don’t rub it roughly.
As soon as you’ve cleaned the section, use a sponge
to
remove the
suds.
Rinse the section with a clean, wet sponge.
Wipe
off
what’s left with a slightly damp paper towel
or
cloth.
Then
dry
it immediately with an air hose, a hair dryer
or
a heat lamp.
NOTICE
I
Be
careful with
a
hair dryer
or
heat lamp. You
could
scorch the fabric
Wipe with a clean cloth.
6-58