Cisco 2500 Series User Manual

3-5
Cisco Video Surveillance 2500 Series IP Camera User Guide
OL-19273-02
Chapter 3 Configuring and Managing the IP Camera
Setup Windows
– Product Process
– Initialization
– Complexity
• Applications
– Mail & FTP
– Motion Detection
– Event
– SNMP
– Alarm I/O Ports
– PTZ (RS-485)
• Status
– System
– Audio Video
– Network
– Syslog & Log
– Video Log
Setup Windows
The Setup windows let you configure a variety of basic and advanced settings for the IP camera, and to
designate IP addresses that are allowed or denied access to the IP camera.
The following sections describe the Setup windows in detail:
• Basic Setup Window, page 3-5
• Wireless Setup Window, page 3-7
• Advanced Setup Window, page 3-11
• IP Filter Window, page 3-14
• EAPOL Window, page 3-14
Basic Setup Window
The Basic Setup window provides options for configuring device and network settings for the IP camera.
To display the Basic Setup window, access the configuration windows as described in the “Accessing the
IP Camera Windows” section on page 2-6, click Setup, then click Basic Setup.
If you change any options except the Current Date/Time in the Basic Setup window, you must click Save
to save the changes. To discard the changes, click Cancel before clicking Save. These buttons appear at
the bottom of the window. You may need to scroll down to see them.
Table 3-2 describes the options in the Basic Setup window.

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English