Cisco 2500 Series User Manual

3-14
Cisco Video Surveillance 2500 Series IP Camera User Guide
OL-19273-02
Chapter 3 Configuring and Managing the IP Camera
Setup Windows
IP Filter Window
The IP Filter window provides options for controlling access to the IP camera by designating a list of IP
addresses that can access the IP camera and a list of IP addresses that cannot access the IP camera.
To display the IP Filter window, access the configuration windows as described in the “Accessing the IP
Camera Windows” section on page 2-6, click Setup, then click IP Filter.
If you change any options in the IP Filter window, you must click Save to save the changes. To discard
the changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You
may need to scroll down to see them.
Table 3-5 describes the options in the IP Filter window.
EAPOL Window
The EAPOL window provides options for configuring Extensible Authentication Protocol Over LANs
(EAPOL). This protocol is used to authenticate and control user traffic in an 802.1x network.
To display the EAPOL window, access the configuration windows as described in the “Accessing the IP
Camera Windows” section on page 2-6, click Setup, then click EAPOL.
If you change any options in the EAPOL window, you must click Save to save the changes. To discard
the changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You
may need to scroll down to see them.
Table 3-5 describes the options in the EAPOL window.
Ta b l e 3-5 IP Filter Window Options
Option Description
Options Choose the option that specifies how to control IP addresses from which the
IP camera can be accessed:
• Disable—Do not use the IP address filtering feature. In this case, the IP
camera can be accessed from a device with any IP address.
• Enable and deny the following IP address—Lets you designate one or
more IP addresses or range of IP addresses that cannot access the IP
camera. All other IP addresses can access the IP camera.
• Enable and allow the following IP address—Lets you designate one
or more IP addresses or range of IP addresses that can access the IP
camera. All other IP addresses cannot access the IP camera.
Single/Range If you enable IP address filtering, choose either of the following options
from as many drop-down lists as needed:
• Single—Enter an IP address that is denied or allowed access to the IP
camera, depending on the Options setting.
• Range—Enter a range of IP address that is denied or allowed access to
the IP camera, depending on the Options setting.

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English