Cisco 5400 ENCS User Manual

• FDE-enabled disks can be re-used by clear its foreign config and set its state to Unconfigured Good.
RAID Disk Group Rebuild
RAID-1 Disk Group is the only mode can be rebuilt under ENCS-MRAID controller. To rebuild the disk
group, you must provide the disk with same type, equal or larger size than virtual disk.
For More Information
The LSI utilities have help documentation for more information about using the utilities.
For basic information about RAID and for using the utilities for the RAID controller cards that are supported
in Cisco servers, see the Cisco UCS Servers RAID Guide.
Full Avago Technologies/LSI documentation is also available:
• • For hardware SAS MegaRAID - Avago Technologies/LSI 12 Gb/s MegaRAID SAS Software User’s
Guide, Rev. F
• • For embedded software MegaRAID - LSI Embedded MegaRAID Software User Guide
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
45
Supported RAID Controllers and Required Cables
RAID Disk Group Rebuild

Cisco 5400 ENCS Specifications

General

Brand	Cisco
Model	5400 ENCS
Category	Network Hardware
Language	English