Place a MeetMe Conference Call
Procedure
Step 1
Obtain a MeetMe conference number from your system administrator
Step 2
Distribute the MeetMe conference number to all the participants.
Step 3
Go off-hook.
Step 4
Press the MeetMe soft key.
Step 5
Dial the MeetMe conference number.
All other participants can join the meeting by dialing into the MeetMe conference number.
Step 6
To end the MeetMe conference call, all participants must hang up the handset or press the Cancel soft key.
Redial a Number
To redial the most recently dialed number:
• Lift the handset and press the Redialsoft key.
• Press the Redial soft key to make a call using a speakerphone or headset.
• To place the call on a particular phone line, get a dial tone on that line, then press the Redial softkey.
Select the Ringtone
You can set separate ringtone for multiple lines by pressing the Line button. Also, you can set separate a
ringtone for each number when there are multiple phone numbers on the phone.
Note
Cisco Unified IP Phone 6945 User Guide for Cisco Unified Communications Manager Express Version 8.8 (SCCP)
OL-24413-01 23
Operating Your Phone
Place a MeetMe Conference Call
To Next Page
Need help?
General
