Cisco 7905G User Manual

Retrieving a Parked Call
Cisco 7912 Telephone User Guide System Telephone Features 43
620-05600350
3. Press the Park soft key. The display shows “Park number is xxxx” and a voice
prompt repeats the same information.
NOTE: Write down the Park Number because you will need to know it to retrieve this
parked call.
4. Hang up.
Retrieving a Parked Call
NOTE: You can retrieve parked calls using any phone in the system.
1. Pick up the handset or press the speaker button (if available).
2. Dial the call ID number of the parked call you wish to retrieve.
3. Speak with the parked caller.
Music on Hold
Your telephone provides crystal clear voice conversations. However, if you listen
to music on hold, you may notice that some types of music sound slightly distorted.
This is normal. The FrameMaker system has been optimized to transmit and
receive speech; music contains a variety of sounds that are considerably higher
and lower in pitch than the human voice, so some of these musical sounds are not
included in the audio signal.
Mute
The Cisco 7912G model phone does not support a mute function with a specific
Mute button. However, you can monitor a call over the phone speaker where the
called party cannot hear you. See “Monitoring a Call Hands-Free” on page 9 for
more information.
On-hook Dialing
You can dial a number while the handset is on-hook by doing one of the following:
• Dial the phone number on the keypad and:
• press the Dial softkey, or
• pick up the handset
• Press the scroll key and select a speed dial button then press Dial.
• Press the Redial softkey.

Cisco 7905G Specifications

General

Brand	Cisco
Model	7905G
Category	IP Phone
Language	English