6
Connecting Your Phone
This section shows how to use the connectors on your Cisco IP phone.
Your system administrator will configure your new Cisco Unified Wireless IP Phone to connect to the corporate wireless
network and the IP telephony network.
A rechargeable lithium ion battery powers the Cisco Unified Wireless IP Phone 7925G. Before using your phone, you must
install the battery in the phone and then charge the battery. Depending on the type of battery you have, the fully charged battery
provides these hours of service:
• The standard battery provides up to 9.5 hours of talk time or up to 180 hours of standby time.
• The extended battery provides up to 13 hours of talk time or up to 240 hours of standby time.
Installing or Removing the Phone Battery
Install or remove the battery by following these steps:
Install the Battery
1. Insert the battery catches in the slots at the bottom of the phone. Ensure metal contacts on the battery and the phone face
each other.
2. Press the battery to the phone until it locks into place.
Remove the Battery
1. Press up on the locking catch with one hand.
2. With the other hand, hold the battery at the edges and pull out to remove the battery.
To Next Page
Loading...
Need help?
General
