Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2007, 2009 Cisco Systems, Inc. All rights reserved.
Configuring Radio Settings on an Access Point
This module describes how to configure radio settings on a Cisco 800, 1800, 2800, or 3800 series
integrated services router, hereafter referred to as an access point (AP).
Finding Feature Information in This Module
Your Cisco IOS software release may not support all of the features documented in this module. To reach
links to specific feature documentation in this module and to see a list of the releases in which each feature is
supported, use the “Feature Information for Configuring Radio Settings on an Access Point” section on
page 29.
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
Contents
• Information About Configuring Radio Settings on an Access Point, page 2
• How to Configure Radio Settings on an Access Point, page 3
• Configuration Examples for Radio Settings on an Access Point, page 27
• Additional References, page 28
• Feature Information for Configuring Radio Settings on an Access Point, page 29
To Next Page
Need help?
General
