Cisco 800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
5
DETAILED STEPS
Configuring Radio Data Rates on an Access Point
Perform this task to configure radio data rates.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. speed {data-rates | default | ofdm-throughput | range | throughput}
5. end
6. copy running-config startup-config
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Enters configuration mode for the radio interface.
• The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
• The 2.4-GHz radio is port 0, and the 5-GHz radio is
port 1.
Step 4
station-role {root [access-point | ap-only |
bridge [wireless-clients]] | non-root [bridge]}
Example:
Router(config-if)# station-role non-root
Sets the role of the radio interface.
Step 5
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.

Cisco 800 Series Specifications

General

Brand	Cisco
Model	800 Series
Category	Network Router
Language	English