Cisco 800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
19
DETAILED STEPS
Configuring Ethernet Encapsulation Transformation Method on an Access Point
Perform this task to configure the encapsulation transformation method.
Encapsulation Types
When the AP receives data packets that are not 802.3 packets, the AP must format the packets to 802.3
using an encapsulation transformation method. These are the two transformation methods:
• dot1h (802.1H)—This method provides optimum performance for Cisco Aironet wireless products.
• RFC 1042—Use this setting to ensure interoperability with non-Cisco Aironet wireless equipment.
RFC 1042 does not provide the interoperability advantages of 802.1H but is used by other
manufacturers of wireless equipment. This is the default setting.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Enters radio interface configuration mode.
• The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
• The 2.4-GHz radio is port 0, and the 5-GHz radio is
port 1.
Step 4
no dot11 extension aironet
Example:
Router(config-if)# no dot11 extension aironet
Disables Aironet extensions.
• Use the dot11 extension aironet command to enable
Aironet extensions if they are disabled.
Step 5
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.

Cisco 800 Series Specifications

General

Brand	Cisco
Model	800 Series
Category	Network Router
Language	English