• Riser 1—Supports Riser1. Supports single x16 PCIe supporting full height 3/4 length cards in 2 riser
configuration (or) Half-height 3/4-length cards in 3 riser configuration and NC-SI from Pilot4.
• Riser 2—Supports Riser 1. Supports single x16 PCIe supporting only Half-height 3/4-length cards in
3-riser configuration.
• Riser 3—Supports Riser 3A, 3B. PCIe slot 3 with the following options:
• Riser3A Supports single x16 PCIe supporting half height 3/4 length cards in 3 riser configuration
and NC-SI.
• Riser3B Supports single x16 PCIe supporting full height 3/4-length cards in 2 riser configuration
and NC-SI.
• 2 10GBase-T Ethernet LAN over Motherboard (LOM) ports for network connectivity, plus one 1 Gigabit
Ethernet dedicated management port.
• One mLOM/VIC card provides 10G/25G/40G/50G/100G connectivity. Supported cards are:
• Cisco UCS Vic15428 Quad Port CNA MLOM (UCSC-M-V5Q50G) supports:
• a x16 PCIe Gen4 Host Interface to the rack server
• four 10G/25G/50G SFP56 ports
• 4GB DDR4 Memory, 3200 MHz
• Integrated blower for optimal ventilation
• Cisco UCS Vic1477 Dual Port 40/100G QSFP28 (UCSC-M-V100-04)
• a x16 PCIe Gen3 Host Interface to the rack server
• two 10G/25G QSFP28 ports
• 2GB DDR3 Memory, 1866 MHz
• Cisco UCS Vic1467 Quad Port 10/25G SFP28 mLOM (UCSC-M-V25-04) supports:
• a x16 PCIe Gen3 Host Interface to the rack server
• four 10G/25G QSFP28 ports
• 2GB DDR3 Memory, 1866 MHz
The following limitations apply to the Cisco APIC Server M4 and L4:
• Cluster formation isn't supported for UCSC-PCIE-C25Q-04.
• 25 link is not supported with Intel NIC E810XXVDA2 2x25/10 GbE SFP.
• Cisco APIC Server M4-L4 using Intel NIC X710 should always be used with 10G supported copper
switch.
Note
Cisco APIC M4/L4 Server Installation and Service Guide
2
Overview
Overview
To Next Page
Loading...
Need help?
General
