Cisco APIC M3 User Manual

b) With the ejector lever on the drive tray open, insert the drive tray into the empty drive bay.
c) Push the tray into the slot until it touches the backplane, and then close the ejector lever to lock the drive in place.
Figure 15: Replacing a Drive in a Drive Tray
Drive tray screws (two on each side)3Ejector lever1
Drive removed from drive tray4Release button2
Replacing a Front-Loading NVMe SSD
This section is for replacing 2.5-inch or 3.5-inch form-factor NVMe solid-state drives (SSDs) in front-panel
drive bays. To replace HHHL form-factor NVMe SSDs in the PCIe slots, see Replacing HHHL Form-Factor
NVMe Solid State Drives.
Front-Loading NVMe SSD Population Guidelines
The front drive bay supports 2.5- inch NVMe SSDs.
Cisco APIC M3/L3 Server Installation and Service Guide
36
Maintaining the Server
Replacing a Front-Loading NVMe SSD

Cisco APIC M3 Specifications

General

Brand	Cisco
Model	APIC M3
Category	Server
Language	English