EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
45
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Workaround: There is no workaround; however, the issue does not occur when you omit the size
parameter.
• CSCud23647
Symptom: BDI adjacency fails on the standby RSP.
Conditions: The issue can occur during an interface module (IM) reset or router reload.
Workaround: There is no workaround.
• CSCud24704
Symptom: The router crashes.
Conditions: Occurs when you perform an interface module OIR (reset) on the gigabit Ethernet
interface module while the standby RSP is booting.
Workaround: Perform the IM OIR after the standby RSP boots.
• CSCud26379
Symptom: The router displays a CWAN OIR Handler traceback error.
Conditions: Occurs when you perform an interface module OIR (reset) on the gigabit Ethernet
interface module, followed by an RSP switchover.
Workaround: Complete the RSP switchover without resetting the gigabit Ethernet IM.
• CSCud26812
Symptom: The router CLI does not display some SFP PIDs
Conditions: Occurs when you install one of the following SFPs in the router:
–
ONS-SI-155-L2
–
ONS-SI-155-L1
–
ONS-SI-155-I1
Workaround: There is no workaround.
• CSCud28787
Symptom: The 10 gigabit Ethernet interface module (IM) (IM- A900-IMA1X ) flaps.
Conditions: Occurs when the IM passes high traffic volumes for an extended period of time.
Workaround: There is no workaround.
• CSCud28982
Symptom: The router does not process egress CoS marking on an Ethernet service instance.
Conditions: Occurs when you configure QoS on an Ethernet service instance that is a member of a
bridge-domain and uses dot1q encapsulation.
Workaround: There is no workaround.
• CSCud29501
Symptom: The show policy-map command displays an incorrect drop rate value.
Conditions: Occurs when you configuring a policy map that contains a class that applies QoS
policing.
Workaround: There is no workaround; however, the issue has no functional impact. The router
displays the correct number of drops under the policer’s exceeded bps value.
• CSCud33329

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals