EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
7
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Open Caveats—Cisco IOS XE Release 3.7(5)S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 Router in
Cisco IOS XE Release 3.7(5)S.
• CSCtq24011
Symptoms: The routers acts as though local proxy-arp is configured and does a proxy-arp for the
systems in the same subnet.
Conditions: This issue occurs when the router receives ARP request on an interface when the
interface is not fully initialized. The connected routes are not added in the routing table causing the
proxy-arp to reply and thus the wrong ARP is entered.
Workaround: Execute a shutdown followed by a no shutdown on the routers.
• CSCty63969
Symptom: Ping fails to remote MEP.
Conditions: This issue occurs on configure CFM and a ping to remote MEP with packet size greater
than 1478 bytes is performed.
Workaround: There is no workaround.
• CSCtz43158
Symptom: Memory leaks are seen on configuring IP FRR remote LFA on the router.
Conditions: This issue occurs on configuring and un-configuring IP-FRR remote LFA on the router.
Workaround: There is no workaround.
• CSCuc08397
Symptom: When IFM is configured on EVC BD, with encapsulation default in the core, the remote
MEPS are not learned.
Conditions: This issue is observed when encapsulation default is configured towards the core facing
side.
Workaround: There is no workaround.
• CSCuc24927
Symptom: Segmentation faults observed on the router.
Conditions: This issue is seen when IMA, CEM and Serial are configured on different controllers
on the router and the image is loaded.
Workaround: Do not combine IMA, CEM and Serial configurations.
• CSCud55799
Symptom: Multiple priority commands get accepted per policy.
Conditions: This issue occurs when a policy-map with priority is configured in one of its classes.
Adding another class with policer first and then with priority causes this issue..
Workaround: There is no workaround.
• CSCud90362
Symptom: The SYNC packets might go out quite irregularly when PTP master (OC/BC) is
configured on the router.
Conditions: This issue occurs when the router is configured as PTP master.
Workaround: There is no workaround.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals