Cisco ASR 900 Series Release Notes

3
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Limitations and Restrictions
• When you configure the copper and SFP Gigabit Ethernet interface modules on a router with
redundant RSPs, the speed and duplex commands are not visible in interface configuration mode
until you apply a shutdown/no shutdown to the interface.
• Fragmentation is not supported with Multicast traffic.
• The SFP-GE-T module supports only 100 Mbps and 1000 Mbps speeds.
• Load balancing using an odd number of port-channel member links is not supported.
IP Multicast Limitation
• Bandwidth-Based Call Admission Control (CAC) feature is not supported.
IPv6 Limitations
The following limitation applies when using IPv6 on the Cisco ASR 903 Router:
• IPv6 Neighbor Discovery (ND) cache timer expiry is 4 hours. To prevent the neighbour adjacency
from being deleted after the timer expires:
– configure hardware based BFD sessions with the neighbours, or
– configure static IPv6 neighbours, or
– configure the ipv6 nd cache expire timer refresh command.
IS-IS Limitations
• IS-IS over IPv6 is not supported on VRF instances.
• Only one IS-IS process is permitted when you configure IS-IS with the address-family ipv6 and
bfd-all-interfaces commands.
• The IS-IS total and per-stream convergence time increases as the number of prefixes increases.
• The Cisco ASR 903 Router supports up to 3000 IS-IS nodes.
MLPPP Limitations
The following limitations apply when using MLPPP on the Cisco ASR 903 Router:
• All links in an MLPPP bundle must be on the same interface module.
• All links in an MLPPP bundle must be of the same bandwidth.
• The Cisco ASR 903 Router supports a maximum of 16 links per bundle
• To change the MLPPP bundle fragmentation mode between enabled and disabled, perform a
shutdown/no shutdown on the bundle.
• LFI is not supported
• Multiclass MLP is not supported
• The Cisco ASR 903 Router supports MLPPP statistics with the following limitations:
– Packet counters on the bundle display the number of fragments rather than packets.
– Control packets are accounted on the bundle.
• If you increase the maximum transmission unit (MTU) size on an MLPPP interface to a value higher
than the maximum received reconstructed unit (MRRU) value on the peer interface, this can bring
the MLPPP tunnel down. To restore the tunnel, perform a shutdown/no shutdown on the interface.

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English