EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #212 background imageLoading...
Page #212 background image
16
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Caveats in Cisco IOS XE 3.9S Releases
CSCue75372
Symptom: Time-Hog traceback seen after router or IM reloads.
Conditions: This issue occurs on bootup of IM or router.
Workaround: There is no workaround.
CSCue87629
Symptom: INFRA-6-PROCPATH_CLIENT_HOG: IOS shim client “iosd-nile” messages may
appear on the console.
Conditions: This issue occurs when a shutdown followed by a no shutdown command is executed
on the G8032 ring interface of a peer or local device.
Workaround: There is no workaround.
CSCue92393
Symptom: CEM SatoP circuits with the router in Core remain in down state after initial
configuration. The show cem circuit command output on ASR903 shows that the circuits are down.
Conditions: This issue occurs when the CEM SatoP circuits are configured using script via tcl and
tftp_config. This forces a lot of configuration dump on router console simultaneously. The issue may
also be seen after router reload with saved CEM Satop configurations.
Workaround: Perform a controller shutdown followed by a no shutdown on OC-3 IM on the router.
CSCuf05090
Symptom: Standby IM resets continuously with running configuration synchronization failure.
Conditions: This issue occurs after a downgrade of all IMs and the IMS are removed from the slot
and a upgrade is performed.
Workaround: Reload the router completely.
CSCuf35542
Symptom: PFM is fails for about 5minutes after OIR on the master.
Conditions: This issue occurs after OIR is performed two times on the master
Workaround: Wait for 5-6 minutes after the OIR.
CSCuf79397
Symptom: F1 is stuck in init state after the standby RSP reloads.
Conditions: This issue occurs on a reload or OIR of the standby RSP.
Workaround: Reload the standby RSP again.
CSCug05491
Symptom: The router drops traffic on VPLS circuits.
Conditions: This issue occurs when you take the following actions:
Configure REP with VLAN load balancing
Configure VPLS VFI on the VLANs
Issue an stateful switchover (SSO)
Workaround: There is no workaround.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals