Step 14 Repeat Step 6, Step 7 and Step 8.
Step 15 (Optional) Perform FPD upgrade on the RSP5. Use these commands:
An FPD upgrade can be performed after all the FCs/LCs are added to the system.
Note
Example:
sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP0 fpd
sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP1 fpd
Step 16 Reload the system once FPDs are upgraded using the admin hw-module location all reload command.
Migrating from FC1 to FC2 Card
Procedure
Step 1 Remove the FC1 card from slot FC0. Follow the procedure explained in the topic Removing and Replacing
Cards from the Chassis, on page 245.
Step 2 Insert FC2 card in slot FC0. Follow the procedure explained in the topic Replacing Cards in the Chassis, on
page 247
Step 3 Wait for FC2 to come online. Verify the card state using the show controller fabric plane all command. In
the output, Admin State and Oper State value should be 01 (that means the card state is up), Links Down
should be zero, and the values of In pkt count and Out pkt count should be incrementing.
Example:
Router# show controllers fabric plane all
Wed Apr 13 08:32:02.464 PDT
Flags: Admin State: 1-Up 2-Down 12-UnPowered 16-Shutdown
Oper State: 1-Up 2-Down 3-Admin Down
Summary for All Fabric Planes:
Plane Id Admin State Oper State Links Up Links Down In Pkt Count Out Pkt count
=============================================================================================
0 01 01 42 00 5942644519 5942644481
1 01 01 42 00 5906049163 5906047719
2 01 01 42 00 5939106251 5939105048
3 01 01 42 00 5933726816 5933725418
4 01 01 42 00 5931138987 5931137649
5 01 01 22 00 5920246359 5920245399
6 01 01 22 00 5920165028 5920163883
Step 4 Repeat Step1 through Step 3 for migrating remaining FCs from slot FC1 to slot FC6.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
261
Replacing Cisco ASR 9000 Series Router Components
Migrating from FC1 to FC2 Card
To Next Page
Loading...
Need help?
General
