Cisco ASR 903 Release Notes

3
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Limitations and Restrictions
• When you configure the copper and SFP Gigabit Ethernet interface modules on a router with
redundant RSPs, the speed and duplex commands are not visible in interface configuration mode
until you apply a shutdown/no shutdown to the interface.
• Fragmentation is not supported with Multicast traffic.
IPv6 Limitations
The following limitation applies when using IPv6 on the Cisco ASR 903 Router:
• IPv6 Neighbor Discovery (ND) cache timer expiry is 4 hours. To prevent the neighbour adjacency
from being deleted after the timer expires:
– configure hardware based BFD sessions with the neighbours, or
– configure static IPv6 neighbours, or
– configure the ipv6 nd cache expire timer refresh command.
IS-IS Limitations
• IS-IS over IPv6 is not supported on VRF instances.
• Only one IS-IS process is permitted when you configure IS-IS with the address-family ipv6 and
bfd-all-interfaces commands.
• The IS-IS total and per-stream convergence time increases as the number of prefixes increases.
MLPPP Limitations
The following limitations apply when using MLPPP on the Cisco ASR 903 Router:
• All links in an MLPPP bundle must be on the same interface module.
• All links in an MLPPP bundle must be of the same bandwidth.
• The Cisco ASR 903 Router supports a maximum of 8 links per bundle
• To change the MLPPP bundle fragmentation mode between enabled and disabled, perform a
shutdown/no shutdown on the bundle.
• LFI is not supported
• Multiclass MLP is not supported
• The Cisco ASR 903 Router supports MLPPP statistics with the following limitations:
– Packet counters on the bundle display the number of fragments rather than packets.
– Control packets are accounted on the bundle.
• If you increase the maximum transmission unit (MTU) size on an MLPPP interface to a value higher
than the maximum received reconstructed unit (MRRU) value on the peer interface, this can bring
the MLPPP tunnel down. To restore the tunnel, perform a shutdown/no shutdown on the interface.
MPLS VPN Limitation
• MPLS VPN (L3VPN) Fragmentation does not function properly if an access interface has a higher
MTU value than a core interface. To ensure that fragmentation functions correctly, configure the
core interface MTU with a value that exceeds the access interface MTU and relevant headers.
OC-3 IM Limitations
• The optical interface module is designed for OC-3 and OC-12 traffic, but OC-12 functionality is not
currently supported.
• MPLS-TP is not supported over POS interfaces.

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English