10
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Open Caveats—Cisco IOS XE Release 3.10S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 router in
Cisco IOS XE Release 3.10S.
• CSCue36365
Symptom: During initial bootup of the serial interface module, the first character of the first packet
received might be missing.
Conditions: Problem occurs during a cold boot of the serial interface module.
Workaround: There is no workaround. Problem is a transient condition and traffic resumes after
receipt of the first message on the module.
• CSCue42144
Symptom: PHY stops timestamping and the session stays at acquiring state.
Conditions: This issue is observed when you insert the Cu-SFP on the slave.
Workaround: There is no workaround.
• CSCue49537
Symptom: The Cisco ASR 903 router crashes when you perform an OC3 IM OIR.
Conditions: This issue is observed when you have about 700 CEM circuits and perform an OC3 IM
OIR.
Workaround: There is no workaround.
• CSCue87629
Symptom: The following error message is displayed:
INFRA-6-PROCPATH_CLIENT_HOG: IOS shim client ‘iosd-nile’
Conditions: This issue is observed when you use the shutdown and no shutdown commands on
the G8032 ring interface of peer or local device.
Workaround: There is no workaround.
• CSCuf16426
Symptom: FMAN_FP download fails and the following error message is displayed:
%CHUNK-2-BADREFCOUNT errors.
Conditions: Have an MPLS TE in the core and flap the tunnels intermittently.
Workaround: Do not flap the core TE tunnels often.
• CSCug15175
Symptom: The Cisco ASR 903 router falsely displays the following error message saying that a
BFD node is down:
%OSPF-5-ADJCHG: Process 232, Nbr 192.0.2.33 on BDI632 from FULL to DOWN, Neighbor
Down: BFD node down
Conditions: This issue is observed when you configure a BFD software session.
Workaround: There is no workaround.
To Next Page
Loading...
Need help?
General
