Cisco ASR 903 Release Notes

36
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.8S Releases
Open Caveats—Cisco IOS XE Release 3.8(0)S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 Router in
Cisco IOS XE Release 3.8(0)S.
• CSCts95896
Symptoms: The router stops passing traffic on EVC interfaces.
Conditions: Occurs when you issue the default interface command and immediately restore the
configuration. The issue occurs with configurations containing either a large number of EFPs or
features that impact EFP programming at a lesser scale, such as QoS.
Workaround: Wait for the router to clear the old EFP configuration before adding a new
configuration.
• CSCty70119
Symptom: Port shaper rate changes do not take effect.
Conditions: Occurs when QoS policies attached to EVCs on an interface do not include a shaper
configuration; the issue does not occur on EFP policies that include a shaper in a class.
Workaround: Include a shaper in one class of the EFP policy.
• CSCua39109
Symptom: The router displays the following console error message:
%FMFP_ACL-3-ACL_OBJECT_DOWNLOAD: SIP0: fman_fp_image: ACL create/modify for ACL test9
fail to download because Cannot allocate memory.
Conditions: Occurs when the router is running a configuration containing a high number of ACLs.
Workaround: There is no workaround.
• CSCua55522
Symptom: The router experiences intermittent flapping on REP segments.
Conditions: Occurs under the following conditions:
– An lsl-age-timer is configured
– The configuration contains multiple REP segments
– The router is experiencing high CPU utilization.
Workaround: There is no workaround. However, the following can limit the issue:
– Limiting the configuration to a single REP segment
– Using an lsl-age-timer of greater than 500 milliseconds
• CSCua62029
Symptom: The router crashes.
Conditions: Occurs when you configure a service policy with two child policies with the same
name.
Workaround: Create a child service policy with a different name.
• CSCua73104
Symptom: The router does not increment QoS port shaper policy counters displayed by the show
policy interface command.
Conditions: Occurs when you configure -A class-default policy on a physical interface -A
class-based policy on an EVC interface

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English