Cisco ASR 903 Release Notes

13
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Resolved Caveats—Cisco IOS XE Release 3.10S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.10S.
• CSCtx70302
Symptom: Traceback and log messages are seen while performing a multilink bundle shutdown on
the Cisco ASR 903 router.
Conditions: This issue is observed when traffic flows over the multilink bundle.
Workaround: There is no workaround. This issue does not impact the operation of the router.
• CSCua61934
Symptom: When a policy map with priority in class-default is attached to an interface, it is not
rejected.
Conditions: This issue is observed when you configure policy-map having priority in class-default
and attach the policy to an interface.
Workaround: There is no workaround.
• CSCua90879
Symptom: QoS policies with a police statement on the class-default class do not take effect.
Conditions: This issue is observed when you apply a police statement to the class-default class
within a QoS policy on an ingress EVC interface.
Workaround: Apply the police statement to a static class, such as class cos0.
• CSCuc59386
Symptom: IOMD crashes continuously on OC-3 IM. The interfaces on OC-3 IM are not
configurable and the following error message is displayed:
stand-by does not support this command
Conditions: This issue is observed on a Cisco ASR 903 router high availability setup with OC-3 IM.
Workaround: Reload the standby RSP.
• CSCuc60148
Symptom: The router does not shut down when the temperature sensor reaches the shutdown
threshold.
Conditions: Temperature sensor reaches shutdown threshold.
Workaround: Use the facility-alarm critical exceed-action shutdown commands to enable
system shutdown.
• CSCuc83088
Symptom: The router drops traffic while performing a Stateful Switchover (SSO).
Conditions: This issue is observed when the router is running HSRP or VRRP. It occurs when the
destination MAC address is a virtual MAC (vMAC) address.
Workaround: Change the traffic priority and detour traffic before performing an SSO.
• CSCud09100
Symptom: The router accepts a policy with marking at two levels. It should not accept a policy with
marking at two levels.
Conditions: This issue is observed when you apply a policy with marking at two levels.

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English