EasyManuals Logo
Home>Cisco>Network Router>ASR 903

Cisco ASR 903 Release Notes

Cisco ASR 903
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
13
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.8S Releases
Symptom: The Cisco ASR 903 router does not display an alarm when nV satellite authentication
fails.
Conditions: This issue occurs when the ASR 9000 and ASR 903 are in an nV satellite configuration
and the routers are configured with a different serial-number value.
Workaround: There is no workaround.
CSCud26812
Symptom: The router CLI does not display some SFP PIDs.
Conditions: This issue occurs when you install one of the following SFPs in the router:
–ONS-SI-155-L2
–ONS-SI-155-L1
–ONS-SI-155-I1
Workaround: There is no workaround.
CSCud29479
Symptom: The router stops applying QoS configurations.
Conditions: Occurs under the following conditions:
–An Ethernet interface is configured with a single service instance
–A QoS policy is attached to the service instance
–The QoS policy contains a single class containing a match EFP statement.
–You reset the interface to the default configuration.
Workaround: There is no workaround.
CSCud30806
Symptom: The router accepts a QoS WRED configuration containing match-all configurations for
two different prec values, which is not supported.
Conditions: This issue occurs when you configure a policy with a class-map containing match-all
configurations for two different prec values.
Workaround: There is no workaround.
CSCud34346
Symptom: The router crashes with multiple ECMP paths configured.
Conditions: The issue can occur when:
–The router is configured with multiple ECMP paths.
–MPLS IP is not enabled on one of the ECMP paths.
Workaround: There is no workaround.
CSCud38038
Symptom: The router records incorrect delay measurements after a reload.
Conditions: This issue occurs under the following conditions:
–You configure Delay Measurement Message (DMM) on a port-channel interface.
–The port-channel member links are on different interface modules (IMs).
–You reload the router.
Workaround: You can use the following workarounds:

Table of Contents

Other manuals for Cisco ASR 903

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 903 and is the answer not in the manual?

Cisco ASR 903 Specifications

General IconGeneral
BrandCisco
ModelASR 903
CategoryNetwork Router
LanguageEnglish

Related product manuals