EasyManuals Logo
Home>Cisco>Network Router>ASR1002 - ASR 1002 Router

Cisco ASR1002 - ASR 1002 Router Software Configuration Guide

Cisco ASR1002 - ASR 1002 Router
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #335 background imageLoading...
Page #335 background image
Using the Management Ethernet Interface
Common Ethernet Management Tasks
5
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 next-hop-IP-address
Setting the Management Ethernet IP Address
The IP address of the Management Ethernet port is set like the IP address on any other interface.
Below are two simple examples of configuring an IPv4 adress and an IPv6 address on the Management
Ethe
rnet interface.
IPv4 Example
Router(config)# interface GigabitEthernet 0
Router(config-if)# ip address A.B.
C.D A.B.C.D
IPv6 Example
Router(config)# interface GigabitEthernet 0
Router(config-if)# ipv6 address X:X:X:X::X
Telnetting over the Management Ethernet Interface
Telnetting can be done through the VRF using the Management Ethernet interface.
In the following example, the router telnets to 172.17.1.1 through the Management Ethernet interface
VR
F:
Router# telnet 172.17.1.1 /vrf Mgmt-intf
Pinging over the Management Ethernet Interface
Pinging other interfaces using the Management Ethernet interface is done through the VRF.
In the following example, the router p
ings the interface with the IP address of 172.17.1.1 through the
Management Ethernet interface:
Router# ping vrf Mgmt-intf 172.17.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.17.1.1, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms
Copy Using TFTP or FTP
To copy a file using TFTP through the Management Ethernet interface, the ip tftp source-interface
GigabitEthernet 0 command must be entered before entering the copy tftp command because the copy
tftp command has no option of specifying a VRF name.
Similarly, to copy a file using FTP through the Management Ethernet interface, the ip ftp
sour
ce-interface GigabitEthernet 0 command must be entered before entering the copy ftp command
because the copy ftp command has no option of specifying a VRF name.
TFTP Example
Router(config)# ip tftp source-interface gigabitethernet 0

Table of Contents

Other manuals for Cisco ASR1002 - ASR 1002 Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR1002 - ASR 1002 Router and is the answer not in the manual?

Cisco ASR1002 - ASR 1002 Router Specifications

General IconGeneral
BrandCisco
ModelASR1002 - ASR 1002 Router
CategoryNetwork Router
LanguageEnglish

Related product manuals