EasyManuals Logo
Home>Cisco>Network Router>C1111 8P Series

Cisco C1111 8P Series User Manual

Cisco C1111 8P Series
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 20A. Statement 1005
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack. Statement 1006.
Warning
To prevent the system from overheating, do not operate the devices in an area that exceeds the maximum
recommended ambient temperature:
Statement 1047
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection, LAN, PoE. Statement 1044.
Warning
To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 1.75 in. (4.4
cm). Statement 1076.
Warning
Site Selection Guidelines
The Cisco 1100 Series ISRs require specific environmental operating conditions. Temperature, humidity,
altitude, and vibration can affect the performance and reliability of the router. The following sections provide
specific information to help you plan for the proper operating environment.
The Cisco 1100 Series ISRs are designed to meet the industry EMC, safety, and environmental standards
described in the Regulatory Compliance and Safety Information for the Cisco 1100 Series ISR document.
Rack Requirements
For the Cisco <platform name>, use brackets with a 19-inch rack.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
25
Prepare for Router Installation
Site Selection Guidelines

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco C1111 8P Series and is the answer not in the manual?

Cisco C1111 8P Series Specifications

General IconGeneral
BrandCisco
ModelC1111 8P Series
CategoryNetwork Router
LanguageEnglish

Related product manuals