Cisco IE 3000 Series User Manual

B-49
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
Appendix B Installation In a Hazardous Environment
Connecting the Switch to the Power Converter
If an LED is off, the target device might not be turned on, there might be a cable problem, or there might
be a problem with the adapter installed in the target device. See
Chapter 3, “Troubleshooting,” for
solutions to cabling problems.
Step 5 If necessary, reconfigure and restart the switch or target device.
Connecting the Switch to the Power Converter
The Cisco IE 3000 switch can be used with an optional AC/DC power converter (PWR-IE3000-AC).
These sections describe the steps required to connect the switch to a power converter:
• Attaching the Power Converter to the Switch, page B-49
• Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter, page B-52
• Connecting the DC Power Clip, page B-52
• Connecting the Power Converter to an AC Power Source, page B-53
• Connecting the Power Converter to a DC Power Source, page B-57
• Applying Power to the Power Converter, page B-59
Attaching the Power Converter to the Switch
Follow these directions to connect the power converter to the switch:
Warning Explosion Hazard—Do not connect or disconnect wiring while the field-side power is on; an
electrical arc can occur. This could cause an explosion in hazardous location installations. Be sure
that power is removed or that the area is nonhazardous before proceeding. Statement 1081

Cisco IE 3000 Series Specifications

General

Brand	Cisco
Model	IE 3000 Series
Category	Switch
Language	English